Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[9078roman]

prepared another part, it is completely ready except for the place where the gun is, I edit this place while fitting the parts to the 3d model of the boat itself. Left a little..

[9078roman]

this is the penultimate part of the deck covering, the final rear stern remains and that's it, then I move on to painting.

[9078roman]

parts of the above were also corrected (you can see them, I changed the original photos) and, no less important, there will be a new riveting. It also needs to be corrected, I will make a new canvas.

[Shessi]

Beautiful detail R,...how is your eyesight!

S

[9078roman]

Beautiful detail R,...how is your eyesight!

S

My vision is in perfect order. I have one hundred percent.

[9078roman]

The deck covering is completed, the cabin remains, and the fins (rudders) or whatever they are called there. It was very difficult to make it. But I'm done, wait for the next news...

[genXgamer]

G'day 9078roman

Your attention to detail is superb!
They look so nice that I might have second thoughts of sending them to the bottom of the ocean.

[9078roman]

I made the rudders, I also made a detail on the nose (as I believe this is a mine cable cutter), the cabin remains from the main one, and the side railings.

[Mick]

... I also made a detail on the nose (as I believe this is a mine cable cutter)

... this rather was a harbour protection net cutter, because after the U47 attack at Scapa Flow (battleship HMS Royal Oak was sunk), evey harbour was fitted with protection nets against submarines intrusions ... 

https://iainballantyne.com/for-britain-scapa-flow-u-boat-attack-was-a-terrible-feat-of-arms/

https://maritime.org/doc/netsandbooms/index.php

[9078roman]

one side of the cabin is ready, tomorrow I will try to finish the second side. And it remains, to redo the rivets, and make a circular binding on the anchor. Then I will create skins. In parallel, spread those that have already been made on another type of boat ..

The next project will be the Soviet boat of the S-13 type.








It will be made based on this type of boat. The cabin will be trimmed to look like the one on the Soviet boat. I will do this by cutting out the alpha channel. Wait for the next news.

[9078roman]

the rivet has decreased, it will not fit a little with the wheelhouse, but I will not redo it, with the wheelhouse I have almost finished a couple of the remaining doors ... and it will already be possible to paint the skin.

[Shessi]

Very good R!


Looking forward to some paint soon.

Cheers

Shessi

p.s. I think you may have missed one rivet on the lower hull ?...