Hello again guys, I had a go with the WWI aircraft but there are problems.
All those aircraft listed I added and then dropped my stationary planes into the DBW 1916 folder but the existing stationary folder has to be left active or there is a CTD.
There is a problem with the FriedrichshafenGIII, in DBW 1916 this is still the version that uses the S55m to allow it to show. If you add the actual lines to the air for the FriedrichshafenGIII and add the newer version with its own slot you will get a CTD. I played around with this and it is possible to get the sim to load by removing the air entry and you can get a stationary to show but it just adds it to a map and then there is no way to remove or adjust it. ???
The solution is to use the existing set up as is but add the text entries for the S55m to the stationary and technics files.
I added the AEG_CIV/AEG_CIVN to 1916 just to check they and my stationary mod was actually working, thankfully no problem there other than they are raised off the ground, not something I know how to cure though.
Here are the AEGs with the entries as normal and the FriedrichshafenGIII but with the stationary entries for the S55m:
So essentially you should be able to use my existing mod alongside the existing 1916 stationary file without problems except in situations like the FriedrichshafenGIII. Just add the aircraft you want and add the necessary text entries to the stationary and technics files.
When DBW 1916 is updated I'm sure Istvan will already have the newer aircraft and their stationaries sorted, but until then using my stationary mod with the existing one should do for now until the next update.
Hope that helps.
Wishing you all the very best, Pete.