Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[CaptSopwith]

Hi Gents,

Hope you are all doing well. I had a quick question regarding my nVidia settings when running BAT. I've previously had vsync turned off as it would cause intermittent stutters when running vpmodpack. I was wondering, with my system specs below, what the best setup on the nVidia control panel would be to get smooth fps and as much graphical detail as possible. I'll add that I'm running the slightly detuned config for BAT which is posted under the BAT download section. Thanks for all of your help guys!

Cheers

[Vampire_pilot]

here's an old post from Mike and that's also the NVidia settings I use:

These would be valid Nvidia Control Panel settings to start with:

DSR Factors = Off
Anisotropic filtering = 16x
Antialiasing - FXAA = Off
Antialiasing - Setting = 8x
Antialiasing - Gamma correction = On
Antialiasing - Mode = Override any Application Setting
Antialiasing - Transparency = Multisample
Preferred Refresh rate = Highest Available
CUDA - GPUs = All
Triple buffering = Off (This depends, you might want to set it to "on" if you experience tearing or micro-stutters if using a monitor without G-Sync)
Power management mode = Prefer Maximum Performance
Optimize for compute performance = Off
Maximum pre-rendered frames = 3
Monitor-technology = G-SYNC (only if available)
Multi-Frame Sampled AA (MFAA) = Off
OpenGL-rendering GPU = Auto
Shadercache = On
Texture filtering - Anisotropic sample optimization = Off
Texture filtering - Negative LOD bias = Clamp
Texture filtering - Quality = Quality
Texture filtering - Trilinear Optimization = On
Threaded optimization = Auto
Vertical sync = Fast (try other modes if you aren't satisfied...)
Pre-rendered VR-Frames = 1


Mike